AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Cisco asr 92011/19/2023 ![]() Show commands until the card type has been set. Information about the interface module is not indicated in the output of any The interface module is not functional until the card type is set. Shut down all pluggable IM interfaces in system.ĭefault all pluggable IM interfaces in the system. Include MPLS TP tunnels, TE tunnels, BDI interface, Port-Channel interface and Remove all the Virtual Interfaces associated with the IM. Shut down all interfaces that are active in system and which willīe removed during the IM activation process.ĭefault all interfaces that will be removed from the system.Īctivate the correct IM type that is preset in the IM slot. Verify that the correct IM is inserted properly in IM slot Then you do not need to configure the command. If the default value is correct for your network, Some of the required configurationĬommands implement default values that might be appropriate for your network. This section lists the required configuration steps to configure the T1/E1 interface module. You must wait until after the interface module is administratively However, channelization is supported for CEM at the DS0 level.Ī card type change cannot be applied when the interface module isīooting up.
0 Comments
Read More
Leave a Reply. |